There are about 11256 clinical studies being (or have been) conducted in Egypt. The country of the clinical trial is determined by the location of where the clinical research is being studied. Most studies are often held in multiple locations & countries.
The aim of this study is to evaluate whether Trendelenburg maneuver can be used to predict fluid responsiveness in high-risk surgical patients in intensive care unit as compared to Passive Leg Raising test.
The aim of this study is to evaluate the role of ondansetron lozenge on prevention of postoperative nausea and vomiting (PONV) in pediatrics undergoing squint surgeries.
The aim of this study is to estimate the role of ondansetron lozenge on prevention of post-spinal shivering in cesarean section.
1. Evaluating the effect of nicorandil on glycemic control of diabetic obese patients treated with sulfonylureas. 2. Investigating the effect of nicorandil on body weight of diabetic obese patients treated with sulfonylureas.
The present study aims to clinically evaluate and compare the scanning accuracy and the scannability of 2 different materials used in constructing frameworks for implant-supported prosthesis (titanium and PEEK). The objective of the present study is to evaluate the digitization accuracy and scannability of milled titanium and PEEK implant-supported frameworks in intra-oral conditions and to evaluate the accuracy of the superstructures designed and constructed over the intraorally scanned framework.
The patients will be randomized into 2 groups, named group A, B. Group A: The patients will receive Ultrasound guided Genicular nerves block combined with Ultrasound guided IPACK block. Group B: The patients will receive Adductor canal block which will be the control group. The Numerical Rating Scale (NRS) will be used to assess pain intensity. Preoperatively, all study subjects will be trained to use NRS pain scores. The spinal block will be performed. In group A, 15 mL of bupivacaine 0.25% with 2.5 g/mL adrenaline at a concentration 1:4,00,000 will be administered immediately following skin closure. GNB will be performed by using the linear ultrasound probe (10-15 MHz) Sono site M-turbo ultrasonography to scan the long bone shaft with up and down movement to recognize the epicondyle of the tibia and femur. The junctions between the epicondyle and the shafts of the femur and tibia are where the genicular arteries are located; these junctions will be defined as the periosteal areas. The superior lateral, superior medial and inferior medial genicular arteries accompany each genicular nerve. After confirmation of the genicular artery by color Doppler, the needle will be introduced using the in-plane approach and presented in the long axis view. The target point of the needle insertion will be the needle tip beside a genicular artery. Then, a 5 mL volume will be administered after gentle aspiration to prevent a faulty intra-arterial injection at 3 target locations: the superior lateral, superior medial and inferior medial genicular nerves. This will be Followed by the procedure for the IPACK block. In group B, A 22 Gauge 80 mm needle will be guided from lateral to medial to this area called the adductor canal using in-plane technique. 20 mL of 0.5% bupivacaine will be injected with peri-arterial spread after negative aspiration under sterile conditions. TKA will be performed by an orthopedic surgeon by placing three-compartment prostheses with a minimally invasive mini-midvastus approach and using hand-mixed cementing techniques.
Assessment of healing of thin and perforated cornea after surgical treatment by anterior segment optical coherence tomography
The goal of this interventional study is to learn if accelerated Intermittent Theta Burst Stimulation can improve symptoms of 30 participants with Unipolar depression in higher manner than symptoms of 30 participants with bipolar depression
the aim of the current study is to evaluate the effectiveness of the laser acupuncture in comparison to the electroacupuncure for controlling gag reflex in children
Implant supported superstructure is necessary for long term success and durability of the implant itself in terms of stresses distribution and fracture strength capability. Stresses falling on an implant are too much greater than those applied on a tooth structure with a periodontal ligament offering a degree of elasticity. The important mechanical and physical properties of materials used for the fabrication of dental prostheses include adequate flexural and tensile strength and modulus of elasticity, maximum fracture resistance, optimal bond strength and adequate polishability.