Clinical Trial Details
— Status: Active, not recruiting
Administrative data
NCT number |
NCT04147299 |
Other study ID # |
19-1141 |
Secondary ID |
|
Status |
Active, not recruiting |
Phase |
|
First received |
|
Last updated |
|
Start date |
February 15, 2020 |
Est. completion date |
May 31, 2025 |
Study information
Verified date |
May 2023 |
Source |
University of Colorado, Denver |
Contact |
n/a |
Is FDA regulated |
No |
Health authority |
|
Study type |
Observational
|
Clinical Trial Summary
The primary objective of this research protocol is to advance the understanding of
cardiopulmonary and right ventricular (RV) performance among individuals with cardiomyopathy
(heart failure with reduced ejection fraction [HFrEF], heart failure with preserved ejection
fraction [HFpEF]), as well as athletes engaging in endurance/prolonged exercise, who are at a
high risk of an acquired cardiomyopathy during/following completion of an endurance event.
Description:
For completion of specific aims 1-2, the protocol will be identical. Specific aim 1 involves
analysis of patients with HFrEF as defined above; specific aim 2 involves analysis of
patients with HFpEF as defined above. The protocol for specific aim 3 (analysis of endurance
athletes) incorporates a different protocol than that described for specific aims 1-2.
For HFrEF and HFpEF patients (specific aims 1-2): There will be a single visit for testing.
This visit will involve a baseline assessment of hemodynamics using a Swan-Ganz catheter,
followed by invasive exercise testing with a high-fidelity conductance catheter, which
provides the real-time RV PV loops. The Swan-Ganz catheter is a 7-French flexible catheter
that is routinely used for hemodynamic assessment for clinical and research purposes (we are
currently using this catheter for COMIRB #16-1635, and COMIRB #17-1042). The purpose of this
catheter is to determine baseline hemodynamic parameters (in "layman's terms", to describe
left and right-sided filling pressures, as well as pressures in the lungs), and to determine
resting cardiac output. The Swan-Ganz catheter will be inserted and removed after obtaining
these measurements - it is anticipated that this procedure will take 10-15 minutes. The
primary investigator for this study, Dr. Cornwell, routinely performs these procedures in
both clinical and research settings, and will use standard techniques for catheter insertion.
Ultrasound guidance will be used to identify the right internal jugular vein, where the
catheter is inserted, and fluoroscopy will be used to guide placement of the catheter for
hemodynamic monitoring.
After completion of the baseline hemodynamic assessment, the Swan-Ganz catheter will be
removed. Thereafter, the high-fidelity conductance catheter will be inserted into the RV
using standard techniques. This catheter is also a 7-French flexible catheter (currently
being used for COMIRB #17-1042) that has a pressure manometer on the tip, along with several
conductance electrodes that continuously measure volume in the ventricle - by continuously
recording changes in pressure and volume throughout the cardiac cycle, the catheter generates
the "PV loop". These catheters provide information that is not available with standard
Swan-Ganz catheters (refer to outcome measures listed above). Following insertion of the
conductance catheter, an arterial line will be placed in either the left or right radial
artery, using sterile technique and with ultrasound-guidance. The purpose of this catheter is
two-fold: 1) to provide a gold-standard assessment of BP during exercise; and 2) to measure
arterial oxygen saturation to calculate a cardiac output from the Fick equation. Baseline
hemodynamic assessment will involve monitoring for approximately 5 minutes during spontaneous
breathing, followed by approximately 6 minutes of breathing at a controlled respiratory rate
(12 times per minute), which allows for determination of short-term blood pressure
variability after controlling for the effect of respiratory variation, followed by Valsalva
maneuver and vasomotor reactivity (inspiratory breath-hold for 30 seconds).
Following insertion of the conductance catheter, arterial catheter and acquisition of
baseline data, the patient will be positioned on an upright cycle ergometer. In the event
that the patient is not able to perform upright exercise, a supine ergometer will be used.
The patient will then complete exercise at two submaximal workloads (below their ventilatory
threshold) that simulate real-world scenarios/normal activities of daily living, followed by
peak exercise. To obtain submaximal data, workload on the bicycle will begin at 0 Watts.
Every 1-2 minutes, workload will be steadily increased, generally in 12.5-25 Watt-increments,
until the patient indicates that the rate-of-perceived exertion (RPE) score is 7-9, on a 6-20
point scale.24 This workload will correspond to "mild" exercise, or steady-state 1. Workload
will be held at this level for approximately 4-5 minutes, during which time hemodynamic data
will be obtained. Thereafter, workload will again be increased in 12.5-25 Watt increments
until the participate indicates that the RPE score is 11-13.24 This workload will correspond
to a "moderate" exercise, or steady-state 2. Workload will be held at this level for
approximately 4-5 minutes, during which time hemodynamic data will be obtained. The patient
will then be allotted a 5-10 minute break. After the break, the patient will complete a
symptom-limited cardiopulmonary exercise test, whereby workload will begin at 0 Watts, and
generally increase every 1-2 minutes in 12.5-25 Watt increments until exhaustion. Hemodynamic
data will be continuously recorded, and final data will be obtained at the peak workload
achieved. This protocol will allow for acquisition of data at five different positions: 1)
supine rest; 2) upright rest; 3) steady-state 1, or "mild" exercise; 4) steady-state 2, or
"moderate" exercise; and 5) peak exercise. Blood samples will be collected at each of these
stages: blood will be tested for arterial and venous oxygen saturation levels (to calculate a
Fick cardiac output), as well as a venous/capillary lactic acid level by finger stick. Lactic
acid levels will be used to assess the participant's work effort at each stage of exercise
(as a "rule-of-thumb", submaximal levels of exercise have an associated lactic acid level of
below 4mmol/L. A complete blood count will be obtained in the supine resting position to
determine hemoglobin concentration, which will be used to calculate Fick cardiac output
during all stages of exercise. Following completion of the study, the patient will be
returned to a supine position and de-instrumented. This protocol is very similar to protocols
used as part of COMIRB #16-1635 and #17-1042; based on our experience with these protocols,
it is anticipated that this study will last approximately 4-5 hours.
For Endurance Athletes (specific aim 3): There will be two visits for this study:
- Visit 1: Baseline Assessment: this visit will include informed consent, study
enrollment, history and physical, followed by a non-invasive cardiopulmonary exercise
test (CPET) with stress echocardiography. The CPET will be conducted in the following
manner: a resting echocardiogram will be performed to assess cardiac structure and
function and rule-out any structural disease. The athlete will then complete a
symptom-limited CPET, whereby workload on the ergometer will start at 0 Watts, and
increase by approximately 50-Watt increments every 1-2 minutes until exhaustion.
Immediately following completion of the test, echocardiography will be repeated to
assess wall motion and cardiac structure at peak exercise. During this test, heart rate
(HR) and rhythm, as well as blood pressure (BP) will be continuously monitored
non-invasively. In the event that any abnormalities are detected during this period of
time, the patient will be excluded from further testing. Results of the test will be
communicated with the participant.
- Visit 2: "Race-Day". On this day of testing, participants will complete a non-contrast
cardiac MRI prior to and immediately following testing. Testing will include a
timed-trial for completion of a 180km cycling event (the distance of the bicycling
portion of an Ironman event)22.
- Baseline cardiac MRI: to evaluate baseline cardiac structure and function. This
will be completed in the Brain Imaging Center at the Anschutz Medical Campus.
- Testing: after completion of cardiac MRI, participants will be escorted to
laboratory for testing. Athletes will undergo insertion of a Swan-Ganz catheter
using standard techniques (as described above). Baseline hemodynamic assessment
will be obtained to determine left and right-sided filling pressures, as well as
cardiac output. Spontaneous and controlled breathing, as well as Valsalva maneuver
and vasomotor reactivity, will also be obtained. Following this assessment, the
Swan-Ganz catheter will be removed and a conductance catheter will be inserted in
order to obtain RV PV loops. Supine resting loops will be acquired. Thereafter, the
athlete will be positioned on an upright bicycle. The participant will then
complete a timed-trial (ie, we will record the time required to completion of the
event). The distance will be the same for all participants and will be 180km (the
distance of the cycling portion of an Ironman competition)22. Participants will be
instructed to complete the event at a pace that they are comfortable with and is
compatible with their typical racing pace. Breaks during cycling will be allotted
at the athlete's request. Food and drink/snacks will be allotted at the athlete's
request (the goal is to simulate a real-world race-day scenario). During the event,
HR and rhythm, as well as BP, will be continuously recorded. RV PV loops, as well
as gas-exchange metrics via indirect calorimetry, will be analyzed continuously and
recorded every 30 minutes during the event. Following completion of the event, the
athlete will be placed back in supine position, and post-event hemodynamic
assessment will be completed. This will include acquisition of resting RV PV loops
from the conductance catheter, followed by re-insertion of the Swan-Ganz catheter
for spontaneous and controlled breathing, as well as a Valsalva maneuver and
vasomotor reactivity. The participant will then be de-instrumented and the
test-phase completed. Based on our experience with performing similar assessments,
coupled with typical cycling times to complete 180km cycling events, it is
anticipated that this test will take ~6 hours to complete.
- Post-Test cardiac MRI: to evaluate cardiac structure and function following
completion of test.