Surgical Treatment of Peri-implantitis Using a Bone Substitute With or Without a Resorbable Collagen Membrane

Surgery Clinical Trial

Official title: Surgical Treatment of Peri-implantitis Using a Bone Substitute With or Without a Resorbable Collagen Membrane. A Randomized Clinical Trial

Status Enrolling by invitation

Clinical Trial Summary

The objective of the present randomized clinical trial will be to compare two surgical methods of treating peri-implantitis. This study will determine if surgical debridement of peri-implantitis bone defects, including air decontamination of implant surfaces, in combination with the placement of a bone graft, differs in treatment outcomes compared to placing the same bone graft material with a resorbable collagen membrane placed over the bone graft.

Clinical Trial Description

The purpose of the study is to compare treatment outcomes of peri-implantitis defects when using a defect fill substitute (InterOss Collagen), against the treatment outcome when placing the same defect fill substitute with a resorbable collagen membrane (InterCollagen Guide). There is no current literature to suggest that placing a collagen membrane over a bone grafting material in an infrabony defect of more than 270 degrees is more effective than placing the bone graft material alone. The present study will help in understanding if such defects require an additional placement of a collagen membrane which could increase the cost of the procedure for the practitioner and the patient.

The study will be conducted at the University of Pittsburgh School of Dental Medicine Graduate Periodontics Department. A detailed description of research activities during each patient visit is provided below.

Screening Visit (V0):

Prior to starting any of the procedures, the subject will complete the informed consent interview. Patients will be screened to assess for inclusion in the study. Vitals (blood pressure and heart rate) will be measured and medical history will be discussed. Limited field of view (FOV) cone beam computed tomography (CBCT) scan will be taken and examined prior to the study to determine the presence of a 270 degree circumferential boney defect for inclusion in the study. Probing pocket depths (PPD), plaque sites, mobility and bleeding on probing (BOP) are clinical measurements that will be completed. A periapical (PA) radiograph will be taken to confirm a crater like defect >=3mm for inclusion in the study. Clinical photographs will be taken of the teeth and inside of the mouth. The visit will take approximately 1.5 hours. All procedures will be performed by the faculty and Periodontics graduate resident.

Pre-surgical phase (V1):

If the patient is eligible and willing to participate in the study following the screening visit, they will return for V1. Their medical history will be reviewed, blood pressure and heart rate will be measured. Any adverse events from the previous visit will be assessed. The prosthetic superstructures (implant crowns) will be removed followed by placement of cover screws. PPD will be measured twice (with and without the implant crown). Bleeding on Probing (BOP), mobility, and plaque sites will be recorded. Clinical photographs will be taken. Prosthesis superstructure will be scanned with a Trios digital scanner to be able to study the emergence profile. Generalized supragingival debridement will be performed. Patients will be informed that newly fabricated crowns might be needed after the treatment as part of the study. During this visit, patients will be also re-instructed and emphasized on maintaining proper at-home oral hygiene measures with a soft-bristled toothbrush for minimizing trauma to marginal soft tissues. The visit will take approximately 2 hours. All procedures will be performed by the faculty and Periodontics graduate resident.

Surgical treatment procedures (V2) After 4 to 6 weeks, the patient will undergo regenerative surgical procedure. Their medical history will be reviewed, blood pressure and heart rate will be measured. Any adverse events since the previous visit will be assessed. The Study individuals will receive a local anesthetic as needed by the surgeon. Intra-sulcular, and if necessary, vertical releasing incisions will be made. Soft tissue flaps will be elevated at buccal and lingual aspects providing adequate access. Granulation tissue and mineralized deposits at implants will be removed using titanium curettes. The implant surfaces will be decontaminated with airflow. Once the surgical site was debrided, clinical intra-surgical measurements will be made. The measurement of peri-implant defect depth will be made clinically intra-surgically. Defects will be measured using a prefabricated acrylic stent stabilized on adjacent teeth. The depth will be measured from the marked area of the stent to the deepest point of the defect. This will be termed the clinical vertical defect fill (DF), and assessed at each implant site (buccal, lingual/palatal, mesial, distal) as follows: DF = (Measurement at the surgical treatment) - (Measurement at re-entry procedure). The defect resolution (DR) on the other hand will be measured as the percentage of the defect that was filled with bone at the follow up compared to the original defect depth.

Thereafter, study individuals will be randomized to control or test groups using the SPSS randomization method (SPSS PASW 23.0 statistical software package, SPSS Inc., Armonk, NY, USA). Depending on the randomization, one of the following therapies was used: (a) (control group); bone grafting alone (InterOss Collagen) will be placed. (b) (test group); the intraosseous component will be filled with bone grafting (InterOss Collagen) and covered with a resorbable collagen membrane (InterCollagen Guide). InterOss Collagen is an FDA cleared for use in guided bone regenerative procedures. InterOss Collagen is a bovine derived anorganic hydroxyapatite collagen composite composed of 90% bovine granules and 10% collagen fibers molded in a block form. InterCollagen Guide is an FDA cleared porcine derived resorbable collagen membrane intended for periodontal and dental surgeries. In both groups, if needed, a periosteal releasing incision will be made to allow complete coverage of the wound area. In both study groups, surgical soft tissue flaps will be sutured with interrupted sutures without tissue tension using 4/0 or 5/0 PGA providing full wound closure. Clinical photographs will be taken again, and surgical video may be recorded when possible. All study individuals will receive postoperative antibiotics and prescribed post-operative pain relievers, as well as care instructions.

The postoperative medications may include:

Amoxicillin 500 mg 3 x 7 days

• Clindamycin 300 mg 4 x 7 days Ibuprofen 600 mg PRN Chlorhexidine 0.12% rinse 2 x 2 weeks Instructions not to wear any removable prosthesis during the healing phase

• Administer if drug allergy to Amoxicillin The visit will take approximately 2.5-3 hours. All procedures will be performed by the faculty and Periodontics graduate resident.

4 weeks post op (V3) After 4 weeks (± 2 days), the patient will return for follow-up. Any changes to their medical history will be reviewed, blood pressure and heart rate will be measured. Any adverse events since the previous visit will be assessed. Sutures will be removed. Clinical photographs will be taken again. Subject's pain assessment forms will be collected. The visit will take approximately 0.5-1 hours. All procedures will be performed by the faculty and Periodontics graduate resident.

Re-entry procedure and replacement of superstructures (healing abutment) (V4) After 4 months of uninterrupted healing, patients will return for the re-entry procedure. Any changes to their medical history will be reviewed, blood pressure and heart rate will be measured. Any adverse events since the previous visit will be assessed. A standardized PA radiograph will be taken at this visit. Intrasulcular incision will be performed on the adjacent teeth and midcrestal incision at the implant location. Full thickness flap will be elevated, and the same defect measurements taken during the surgical procedures will be performed to obtain clinical changes in peri-implant bone levels. Where the defect fill will be measured using an acrylic stent as the difference in millimeters between the initial measurements taken at baseline and the depth of defect present at follow up. Implant cover screws will be replaced by appropriate healing abutments, followed by single interrupted sutures for re-adaptation of the flap. Clinical photographs will be taken again, and surgical video may be recorded. Finally, a periodontal maintenance will be performed. The visit will take approximately 2 hours. All procedures will be performed by the faculty and Periodontics graduate resident. During this period, if needed new crowns will be designed, fabricated, and delivered to all patients and for all treated implants.

Post op after stage 2. (V5) Approximately 2 weeks after V4, subjects will return for V5. Any changes to their medical history will be reviewed, blood pressure and heart rate will be measured. Any adverse events since the previous visit will be assessed. Subject pain assessment form will be completed. Sutures will be removed. Digital impression will be taken with the Trios hand-held scanner, and patient will be referred to receive a new crown, if needed. If no new crown is needed, the old crown will be replaced at the next visit. Clinical photographs will be taken again. The visit will take approximately 1-2 hours. All procedures will be performed by the faculty and Periodontics graduate resident.

Crown placement/replacement (V6) Approximately 1 month after V5, the subjects will return for the Implant Crown replacement. Any changes to their medical history will be reviewed, blood pressure and heart rate will be measured. Any adverse events since the previous visit will be assessed. The old crown or the new crown will be placed in the treated area. A radiograph may be taken to assist in placement. The visit will take approximately 1- 2 hours. All procedures will be performed by the faculty and Periodontics graduate resident.

8 months visit (V7) For V7, subjects will return at approximately 8-months post-op. Any changes to their medical history will be reviewed, blood pressure and heart rate will be measured. Any adverse events since the previous visit will be assessed. Probing pocket depth (PPD), BOP, plaque, and mobility measurement will be recorded. Radiographic measurements (bone fill) will be obtained as performed at the pre-surgical visit (time point 0). Dental prophylaxis and periodontal maintenance will be performed. Clinical photographs will be taken again. The visit will take approximately 0.5-1 hours. All procedures will be performed by the faculty and Periodontics graduate resident.

12 months visit (V8) The final visit will occur at 12 months post-op. Any changes to subject's medical history will be reviewed, blood pressure and heart rate will be measured. Any adverse events since the previous visit will be assessed. Probing pocket depth (PPD), BOP, mobility and plaque measurements will be taken as in previous visits. Radiographic measurements (bone fill) will be obtained as performed at the pre-surgical visit (time point 0) using a standardized PA radiograph. Periodontal maintenance will be performed. Clinical photographs will be taken again. The visit will take approximately 0.5-1 hours. All procedures will be performed by the faculty and Periodontics graduate resident.

Clinical measurements at baseline, 4- 10 months after surgery

• The following baseline procedures will be performed; (a) Intra-oral photographs and intra-oral radiographs of the implant sites; (b) clinical recording of full mouth plaque scores (FMPS) (presence of dental plaque along the peri-implant mucosal margin (gingival margin at teeth) was expressed as a percentage of examined sites within each subject including four sites per tooth and implant, (c) clinical recording of local plaque score (LPS) (presence of dental plaque along the mucosal margin at four sites of each treated implant and expressed as a percentage of implant sites within each subject), (d) clinical recording of probing pocket depths (PPD) (at all teeth, and the specific implant in the study (six sites; implant/tooth) to the nearest millimeter with a periodontal probe (e) clinical recording of full mouth bleeding score expressed as percentage of assessed surfaces with bleeding on probing (f) clinical recording of recession at the peri-implant mucosal margin (buccal/lingual- palatal) relative to a fixed reference point on implants and (g), clinical recording of presence/absence of suppuration (SUP) at the implant (6 sites/implant).

• Peri-implant defect depth will be made clinically intra-surgically. Defects will be measured using a prefabricated acrylic stent stabilized on adjacent teeth. The depth will be measured from the marked area of the stent to the deepest point of the defect. This will be termed the clinical vertical defect fill (DF), and assessed at each implant site (buccal, lingual/palatal, mesial, distal) as follows: DF = (Measurement at the surgical treatment) - (Measurement at re-entry procedure). The defect resolution (DR) will be measured as the percentage of the defect that was filled with bone at the follow up compared to the original defect depth.

• MBL will be calculated based on standardized radiographs using registered bite-block with a Rinn (Dentsply Rinn, Elgin, IL, USA) film holder and expressed as the distance from the implant shoulder to the most coronal bone-to-implant contact (BIC) on the mesial and distal side of the implant. The mean values will be calculated for each implant. In the case that the bone levels around the study implants are hidden or difficult to read, new radiographs will be taken. Peri-implant marginal bone levels will be measured using the ImageJ software. The software will be calibrated for every single image using the known implant length or the length of the implant collar. Measurements of the mesial and distal bone crest level adjacent to each implant will be rounded to the nearest 0.1 mm. Implants with bone up to the coronal margin of the implant collar will be given a value of zero. Mesial and distal measurements of each implant are averaged, and a mean calculated at patient level and then at group level. Implant failure: It will be defined as implant mobility assessed from force applied with two hand instrument), pain, or neuropathy. Composite definition of successful treatment outcome: A composite therapeutic endpoint composed of no evidence of BOP or evidence of BOP grade 1 and with no suppuration at any of four assessed sites per implant PPD ≤5 mm, and with ≥1.0 mm defect fill will be used to define a successful treatment outcome. Thickness of soft tissues will be measured with a 1.0-mm marked periodontal probe on the top of bone crest in the center of the implant. This will ensure direct visibility of mucosal thickness during measurement. ;

Related Conditions & MeSH terms

• Peri-Implantitis
• Surgery

• NCT number: NCT05699343
• Study type: Interventional
• Source: University of Pittsburgh
• Status: Enrolling by invitation
• Phase: N/A
• Start date: January 30, 2023
• Completion date: December 2026