View clinical trials related to Radius Fractures.
Filter by:The aim of the study was to investigate the effects of early manual therapy on function, pain, range of motion (ROM), hand and pinch grip strength and disability level in patients underwent volar plating after distal radius fracture (DRF). Patients were randomly divided into two groups: Routin Physiotherapy (RP) or Early Manual Therapy (EMT). While RP group received routine physiotherapy, EMT group received routine physiotherapy plus Mulligan's Mobilization With Movement technique. All treatments were done two sessions a week, through 12 weeks. Function, pain, range of motion (ROM), hand and pinch grip strength and disability level of patients were assessed. Measurements were made at postoperative week 3, 6 and 12.
Subjects with acute, displaced distal radius fractures will be randomized at the time of emergency room evaluation to one of two commonly accepted splinting methods for displaced distal radius fractures: sugar tong splints or volar/dorsal clam shell splints. Reduction will be performed in the usual, standard fashion and the selected splint applied. Standard radiographic measurements of alignment, including radial height, volar tilt and inclination will be measured on pre- and post- reduction radiographs by a single reviewer- who will be blinded to splint application type. At the first fracture follow-up visit, typically occurring between 5-10 days, as in standard practice, repeat radiographs of the wrist will be taken, and the same reviewer will measure alignment. As a secondary outcome, patients will also complete the disabilities of the arm, shoulder and hand (DASH) questionnaire at this visit, to compare patients' ability to perform activities of daily living with their respective splints.
The current status of the disease under study. Including natural history, disease prognosis. Distal radial fractures (DRF, distal radius fractures) are the most common fractures, allowing the user to lock the steel plate to accelerate the recovery of the wrist, but related injuries such as the triangular fibrocartilage cartilage complex (TFCC) tear or distal radius ulna joint (DRUJ) ligament tear with DRUJ instability requires time fixed or further repair surgery. If these issues are ignored, there will be weakness in the future. The ulnar shortening commonly used by hand surgeons is to improve the damage of TFCC or DRUJ instability. In the case of distal radial fracture combined with DRUJ instability, it is not clear that the distal radial fracture combined with DRUJ instability patients has long-term prognosis.
The purpose of the present study is to investigate pressure algometry and pressure-induced referred pain areas in pain free individuals with a history of distal radius fracture (fully recovered) compared with age and gender matched healthy controls without history of fracture. It is hypothesized that individuals with a recovered radius fracture will have a facilitated referred pain patter towards the wrist but normal pressure pain sensitivity.
The aim of the study is to assess the responsiveness of the Assessment of Motor and Process Skills (AMPS) in a population of patients undergoing rehabilitation following hand surgery, as this has not previously been investigated. Methods: Patients are included from the department of physical and occupational therapy at Silkeborg Regional Hospital in the period November 2017 to May 2018. A total of 50 patients, who have been referred for specialized occupational therapy rehabilitation following finger or hand surgery, will be included. At baseline and follow-up (after 8 weeks) all patients are assessed with AMPS, Canadian Occupational Performance Measure (COPM), hand grip strength and joint range of motion using standardized methods. Responsiveness to change is evaluated using an anchor-based method, comparing AMPS scores with the scores on the Global Rating Scale. The area under the ROC curve will be calculated, and an area under the curve of 0.7 is considered acceptable. Convergent and discriminative validity of the AMPS will be assessed across the different instruments used. Thus the investigators expect a higher correlation between AMPS and COPM and lower correlation between AMPS and hand grip strength and range of motion.
We plan to compare 2 types of plating systems for volar plating of distal radius fractures (Aptus 2.5® Medartis AG, Basel, Switzerland vs. INTEOS 2.5® - Hofer Medical GmbH and Co KG, Austria) in a prospective single-blinded controlled clinical trial.
This study prospectively compares the performance of an above-elbow cast (long arm cast) and a below-elbow cast (short arm cast) to maintain reduction in conservatively managed distal radius fractures.
The primary objective of this study is to evaluate the sedative, and analgesic effects of intranasal (IN) Dexmedetomidine (DEX) in children presenting to a Pediatric Emergency Department (PED) who undergo conscious sedation for reduction of closed distal forearm fractures when compared to those receiving intravenous (IV) Ketamine. The secondary objective is to compare each sedation technique for safety and procedural outcomes.
Interferential current is a form of electrotherapy that is obtained by placing two different plates that produce medium frequency waveform current, resulting in a low frequency interferential waveform in deeper tissues. It was shown interferential current electrotherapy is beneficial for reduction of traumatic edema in tissues and pain control. Patients with conservatively managed distal radius fractures were recruited after casts are shed, and were treated with one session(30 minutes) of different protocols of interferential current electrotherapy. Before and after therapy, they were evaluated with volumetry, hand grip strength and visual analogue scale for pain.
This study is a prospective, departmental funded study examining the outcomes of Low Dose CT scans compared to Conventional Dose CT scans in patients who present to Duke University with a Distal Radius Fracture.