The Validity and Tolerability of Awake Calibration of the TOF Watch SX Monitor — CaliRev  

Neuromuscular Blockade Clinical Trial

Official title: The Validity and Tolerability of Awake Calibration of the TOF Watch SX® Monitor: An Interventional Prospective Single Two-center Study

Status Terminated

Clinical Trial Summary

Neuromuscular blocking agents (NMBAs) are frequently used in anesthesia and quantitative monitoring of neuromuscular block is standard care. Normally the calibration of the neuromuscular monitor is done after anesthesia induction to avoid patient discomfort. Under certain circumstances there is no time for the calibration process. In the so-called rapid sequence induction (RSI) the neuromuscular blocking agent has to be injected immediately after the induction agent. As the neuromuscular monitor cannot be calibrated, precise neuromuscular monitoring is not possible, and this is of particular disadvantage, when high doses of non-depolarizing neuromuscular blockers are injected to fasten the onset of neuromuscular block. The primary objective is to validate the measurements of the TOF Watch SX® monitor calibrated in awake patients by comparing them with the measurements obtained with the TOF Watch SX® monitor calibrated after anesthesia induction (Gold standard).

The secondary objective is to evaluate the tolerability of the awake calibration process of the TOF Watch SX® monitor.

Clinical Trial Description

Neuromuscular function will be assessed by acceleromyography of the adductor pollicis with a TOF-Watch SX® monitor on both arms. By randomization it will be chosen on which arm the awake calibration will be done. 5 minutes before the awake calibration process the patients will receive 0.2 µg/kg of sufentanil intravenously. Immediately after the end of the calibration process the patients will rate the pain of the calibration process on a visual analog scale from 0 to 10. Anesthesia will then be induced and immediately at loss of consciousness continuous TOF stimulation will be continued every 12s. Then the calibration process on the other arm will be started, followed by continuous TOF stimulation. After having obtained stable baseline measurements with the TOF-Watch SX® monitor, a bolus dose of rocuronium 0.6 mg kg-1 will be administered intravenously. The trachea will be intubated when full neuromuscular block is reached. No additional rocuronium will be given. Both neuromuscular monitors will be linked via a fiber-optic (TOF-Link®) cable with UBS port to a laptop. Specific software will be used to record the measurements (TOF watch SX® monitor, version 2.2). Neuromuscular monitoring will be continued until a normalized TOF ratio of 0.9 has been obtained on both arms. The onset of neuromuscular block and its spontaneous recovery will be recorded and the results obtained on each arm will be compared. Every patient is his own control. ;

Related Conditions & MeSH terms

• Neuromuscular Blockade

• NCT number: NCT03649672
• Study type: Interventional
• Source: University Hospital, Geneva
• Status: Terminated
• Phase: N/A
• Start date: October 26, 2018
• Completion date: November 9, 2021