View clinical trials related to Jaw, Edentulous, Partially.
Filter by:To compare a flapless technique of alveolar ridge preservation to a flap technique to determine if preserving the periosteal blood supply would prevent loss of crestal ridge width and height.
The aim of this study is to prospectively collect clinical data to confirm the safety and clinical performance of Neodent Titanium Base Abutment and Pro PEEK Abutment in daily dental practice setting, by means of a randomized clinical study of prosthetic rehabilitation using these devices. A total of 48 healed implant sites (at least 4 months post-extraction) shall be included during the sample enrollment (24 patients), which will be randomly divided into two groups, so that each patient receives one implant from each group (removal and non-removal of the abutment placed at the time of surgery). Patients will be followed for 24 months after implant loading. It is expected that there is no difference in peri-implant bone level change between the two treatment groups.
The purpose of this study is to evaluate the outcome of prosthetic survival of the Acuris conometric concept 1 year after permanent restoration, since this is a new mode of retention using friction for seating the crown of single tooth restorations without using cement or screws.
In this retrospective study, approximately 60 patients treated with 6mm short implants (Straumann, SLA (sandblasted, large-grit, acid-etched surface), SLActive (sandblasted, large-grit, acid-etched, hydrophilic surface), 4.1 or 4.8 mm in diameter) will be followed for 4.5-18.2 years. Clinical and radiographic parameters will be assessed in a follow-up examination.
Acqua GM (Grand Morse) Helix implants present an optimized implant design with adapted treatment protocol, allowing for treatment of patients with different bone qualities. The objective of the study is to prospectively collect clinical data to confirm the long-term safety and clinical performance of Acqua GM Helix implants and GM prosthetic abutments in daily dental practice setting, by means of success and survival rates of these devices. Devices will be used according to standard routine in daily practice, according to all indications as specified by the manufacturer in the IFU (instructions for use). patients will be followed for 36 months after implant placement.
Objectives: The aim of the study was to compare histological and histomorphometric results of six bone substitute materials used as graft in two-stage maxillary sinus augmentation model, after 6-month-healing.
The aim of this prospective study was to evaluate the soft and hard tissue changes of immediate implant placement with buccal bone augmentation in sites with thin labial bone wall in the anterior maxillary zone.
In this prospective case series study, 20 patients with an implant-borne single crown following early implant placement with simultaneous contour augmentation will be followed for 10 years. Clinical, radiologic, and esthetic parameters will be assessed. In addition, cone beam computed tomography (CBCT) will be used at 10 years to examine the facial bone wall and compared to the 6 year data.
The trial is designed as a consecutive enrollment prospective one-center study. A minimum of 30 patients will be included in the study. At implant installation, the implant will be randomized to one of the groups (Control: conventional loading, 8 weeks; Test: early loading, 4 weeks). Samples of peri-implant crevicular fluid (PICF) and intrasulcular plaque will be collected at -14, 0 (Baseline: prosthesis delivery), 7 days and 1, 3, 6, 12 months. Prosthesis will be fabricated and delivered as usual, i.e., approximately two weeks after the impressions are taken.
The trial is designed as a consecutive enrollment prospective one-center study. A minimum of 30 patients will be included in the study. At implant installation, the patient will be randomized to receive one of the two types of implants (Control: internal hexagon connection implants (CON.INT); Test: Morse taper connection implants (MT-12)). Samples of peri-implant crevicular fluid (PICF) and intrasulcular plaque will be collected at -21 (second-stage surgery), -14 (impressions), 0 (Baseline: prosthesis delivery), 7 days and 1, 3, 6, 12 months. Prosthesis will be fabricated and delivered as usual, i.e., approximately two weeks after the impressions are taken.