Filter results

Self-etch clinical trials

Phase 1: Researchers test a new drug or treatment in a small group of people for the first time to evaluate its safety, determine a safe dosage range, and identify side effects.
Phase 2: The drug or treatment is given to a larger group of people to see if it is effective and to further evaluate its safety.
Phase 3: The drug or treatment is given to large groups of people to confirm its effectiveness, monitor side effects, compare it to commonly used treatments, and collect information that will allow the drug or treatment to be used safely.
Phase 4: Studies are done after the drug or treatment has been marketed to gather information on the drug's effect in various populations and any side effects associated with long-term use.

View clinical trials related to Self-etch.

Filter by:

Active, not recruiting
Page 1

NCT ID: NCT03798184 Active, not recruiting - Clinical trials for Non-carious Cervical Lesion

Clinical Performance of Prime&Bond Active in Self-etch or Selective-etch Mode With or Without Bioglass

Start date: November 19, 2018
Phase: N/A
Study type: Interventional

Composite restoration of non-carious cervical lesions has always been a challenge for the clinician, considering that the most frequent cause of failure is retention loss. Adhesion of composite restoration may be obtained by following four different etching techniques: total-etch in three steps, total-etch in two steps, self-etch in two steps, and self-etch in one step. Nowadays the tendency is to simplify the adhesive classic protocols. With the introduction of universal adhesives such as Prime&Bond Active (Dentsply Sirona) it is possible to obtain a total-etch pattern (enamel and dentine) without the classic etching technique with orthophosphoric acid. On the other hand, there has been an increase in the awareness of the importance of remaining dental tissue preservation, avoiding preparation of a cavity. This is why it is now preferable to use bioactive glass in order to increase micromechanical retention on the dental surface, instead of the classical approach of preparing the surface with burs. To date, there are no studies evaluating the clinical performance of the universal adhesive Prime&Bond Active on direct resin composite restoration of non-carious cervical lesions neither in a selective-etch mode (enamel etching) or a self-etch mode (no etching) or using sandblasting with bioactive glass. Therefore, the main objective of the study is to evaluate the retention rate of composite restorations using Prime&Bond Active and a previous sandblasted surface with bioglass in a three-year follow-up, as well as the presence of marginal discoloration, marginal integrity and marginal caries.