Stability of the Medial Pivot Total Knee Prosthesis

Osteoarthritis of Knee Clinical Trial

Official title: Stability of the Medial Pivot Total Knee Prosthesis

Status Completed

Clinical Trial Summary

The purpose of this study is to compare objective and subjective measures of knee stability following total knee arthroplasty with a medial pivot design vs. a posterior stabilized design.

Clinical Trial Description

Several different prostheses are available for use in total knee arthroplasty (TKA). These designs aim to replicate the normal kinematics of the knee joint while maintaining stability throughout a full range of motion. The posterior cruciate ligament (PCL) contributes to these functions in the native knee, and if preserved it can function similarly in the prosthetic knee. Prostheses in which the PCL is sacrificed, and its function not replaced by other means, have poorer outcomes. However, various problems with preserving the PCL, including PCL deterioration in arthritic knees and difficulties with proper tensioning, have led to the development of alternative ways to emulate normal femoral rollback and sagittal plane stability. These posterior-substituted (PS) designs substitute for the PCL with either a cam and post mechanism or a symmetrical ultra-congruent tibial insert.

The cruciate-retaining (CR) and PS designs, together with advances in surgical techniques and component materials, have achieved excellent implant survivorship with rates of > 90% at 20 years. Reports of functional outcomes, however, have been variable. One potential area for improvement in TKA is optimization of implant design to better approximate native knee kinematics. In the normal knee, the medial condyle remains stable in the sagittal plane, functioning like a ball-and-socket, whereas the lateral condyle translates anterior to posterior during flexion. The designs of the CR and PS knees do not allow for this medial-centered rotation. Analysis has revealed paradoxical anterior sliding of the femur during flexion, abnormal axial rotation, and condylar lift-off. Edge loading and increased sagittal plane motion may predispose to accelerated polyethylene wear. The posterior stabilized design uses a cam-and-post mechanism in which one piece of the prosthesis has a plastic post that fits into a slot in the other piece of the prosthesis.

A newer design that attempts to address these issues is the medial pivot knee (MP). This design is characterized by an asymmetrical tibial insert in which the medial compartment is ultra-congruent, providing antero-posterior stability and the lateral compartment allows for rollback around a medial axis of rotation i.e uses a ball-and-socket mechanism. This design more accurately recreates normal knee kinematics, reduces anteroposterior instability, and avoids condylar lift-off. Early studies indicate improved polyethylene wear characteristics. Midterm studies report excellent implant survivorship and clinical outcomes.

Several randomized trials have compared the MP knee favorably with other designs. Patients with bilateral TKAs with a different prosthesis on each side preferred their medial pivot knee to a PS, CR, or mobile-bearing (MB) design. A trial comparing the MP and PS designs found greater range of motion (ROM) and better patient-reported outcomes in the MP group at 2 years. There also exists literature reporting poorer outcomes with the MP design. A trial involving 96 patients who had received both an MP knee and an MB knee on contralateral sides found lower ROM, higher complication rates, and worse patient reported outcomes in the MP knee.

Given the lack of consensus in the literature, further investigation is warranted to determine the impact of the MP design on outcomes following TKA. ;

Related Conditions & MeSH terms

• Osteoarthritis of Knee
• Osteoarthritis, Knee

• NCT number: NCT02577978
• Study type: Interventional
• Source: Northwestern University
• Status: Completed
• Phase: N/A
• Start date: April 2014
• Completion date: June 2017