Filter results

CMC clinical trials

Phase 1: Researchers test a new drug or treatment in a small group of people for the first time to evaluate its safety, determine a safe dosage range, and identify side effects.
Phase 2: The drug or treatment is given to a larger group of people to see if it is effective and to further evaluate its safety.
Phase 3: The drug or treatment is given to large groups of people to confirm its effectiveness, monitor side effects, compare it to commonly used treatments, and collect information that will allow the drug or treatment to be used safely.
Phase 4: Studies are done after the drug or treatment has been marketed to gather information on the drug's effect in various populations and any side effects associated with long-term use.

View clinical trials related to CMC.

Filter by:

Not yet recruiting
Page 1

NCT ID: NCT05896410 Not yet recruiting - Clinical trials for Thumb Osteoarthritis

3D-Printed Hand Orthosis Versus Thermoplastic Orthosis

Start date: June 1, 2023
Phase: N/A
Study type: Interventional

This study will investigate the effectiveness of 3D-printed splints for treating thumb osteoarthritis (CMC OA). These splints are made by Occupational Therapists and Physical Therapists out of low-temperature plastic and formed on the patient's hand. 3D printed splints involve photographing the hand and creating a digital file of the splint. This is then printed and fit on the patient. The goal of this cross-over clinical trial is to compare the effectiveness of 3D-printed splints versus thermoplastic splints for treating thumb osteoarthritis (CMC OA). The main question[s] it aims to answer are: Primary objective: • Evaluate the general useability and possible benefits of splint production by 3D printing in a clinical setting Secondary objectives: - Compare the effectiveness of 3D printed orthosis and the low-temperature plastic fabrication manual method in pain reduction - Compare the effectiveness of 3D printed orthosis and the low-temperature plastic fabrication manual method in improving the function. - Compare the satisfaction of patients with the 3D printed orthosis and low-temperature plastic fabrication manual method. - Compare the length of time needed to fabricate each orthosis - Compare the weight of orthosis Participants will provide with two splints (traditional orthosis and 3D-printed orthoses). Participants will use the first orthosis for three weeks, be given a week for washout, and then cross over to the second orthosis.