View clinical trials related to Alveolar Ridge Enlargement.
Filter by:Bone healing after tooth extraction may be affected by defects in the buccal wall of the alveolus, such as fenestrations and dehiscences. Therefore, it is advisable to perform a surgical procedure such as guided bone regeneration after tooth extractions. Different biomaterials are used for this purpose. The aim of this study is to investigate the qualitative and quantitative histological changes in human biopsies taken after 6 months of healing of extraction sockets with buccal wall defects. For this purpose, the defects of 36 patients (18 per group) will be augmented with injectable biphasic calcium phosphate (I-BCP) or bovine xenograft (BX) after extraction. After six months of healing, bone biopsies will be taken and processed to the qualitative and quantitative histological analysis.
The primary objective of this study was to compare the efficacy of using allograft, autogenous tooth graft, and beta-tricalcium phosphate for alveolar ridge preservation (ARP) by examining the alveolar ridge height and width at baseline and 3 months after the ARP both clinically and radiographically. The secondary objective was to evaluate the quality of the newly formed bone using histomorphometric analysis.
Thirty-six patients (19 females and 17 males) that required implant placement in esthetic zone participated in this study and were blindly allocated 12 patients per group, all patients had ARP either with I-PRF with xenograft, HA with xenograft or xenograft alone, the sockets were sealed with free gingival graft harvested from the palate.
The primary aim of the present study is to compare the Sub-periosteal Peri-implant Augmented Layer (SPAL) technique and soft tissue augmentation (STA), performed simultaneously to implant placement, in terms of (i) implant survival rate and (ii) health/disease condition of the peri-implant tissues at 6 and 12 months following implant loading. The secondary aim of the project will be to compare the SPAL technique and STA in terms of intra- and post-operative morbidity. The study is designed as a single-blind, parallel-arm, randomized clinical trial. Patients will be recruited and treated at the Operative Unit of Dentistry, Azienda Unità€ Sanitaria Locale (A.U.S.L.) of Ferrara, Italy, and one University center (Research Centre for the Study of Periodontal and Peri-implant Diseases, University of Ferrara, Italy). Each patient will contribute the study with one sextant ("experimental sextant"). Each eligible patient will be randomly assigned to receive SPAL technique or STA according to a computer-generated randomization list. Surgical procedures will be performed by experienced periodontal and implant surgeons. Two calibrated, blinded examiners will take care of the assessment of clinical and radiographic parameters, Case Report Form (CRF) filling, as well as data extraction from CRFs for the preparation of the study database. The proportion of patients free from peri-implantitis at 12 months following loading will be the primary outcome variable of the study. The proportion of patients with complete resolution of the bone dehiscence (BD), dimensional variations and 12-months characteristics of BD, and patient-reported outcome measures will be the secondary outcomes. The design will test two hypotheses, with a non-inferiority trial in terms of primary outcome and a superiority trial in terms of secondary outcomes.
After tooth extraction, there is a subsequent bone loss as a part of the natural healing of the tissue. Up to 50% of bone loss occurs during the first three months after extraction, jeopardizing a possible implant treatment. Alveolar ridge preservation techniques reduce bone loss, allowing a future implant treatment. Different bone filling materials have been used with good clinical results. The second-generation platelet concentrates (L-PRF) have recently been shown to induce bone regeneration when filling the socket after extraction, with significant biological and economic advantages. The hypothesis of this study is to test whether or not the use of L-PRF in alveolar ridge preservation results in a non-inferior horizontal radiographic change compared with the combination of a xenogeneic bone substitute with a collagen matrix.
After tooth extraction, shrinkage of the bone is expected with 50% reduction of alveolar width. Patients at least 3months after tooth extraction and in need of single oral implant placement in the anterior maxilla with both neighboring teeth present, were invited to participate in an inter-subject RCT if insufficient residual alveolar bone was left for proper implant placement. Guided bone regeneration has been used to recreate bone volume. A combination of xenogenous bone (Creos Xenogain , Nobel Biocare AB, Göteborg, Sweden) and autologous bone chips in a 1:1 ratio, is protected by a membrane fixated in the bone. A resorbable, non-stable membrane (Creos Xenoprotect, Nobel Biocare AB, Göteborg, Sweden) or non-resorbable titanium reinforced d-PTFE membrane (Creos Syntoprotect , Nobel Biocare AB, Göteborg, Sweden) can be used. This study aims to compare the effectivity of the two membranes by measuring changes in bone dimensions. The resorbable membrane has the advantage that it does not need to be removed, whereas the titanium reinforced membrane can protect the rebuilt volume better against external forces. Patients start to take systemic antibiotics (Amoxicilline 1g) and anti-inflammatory medication (ibuprofen 600 mg) 1h pre-operatively. Following local anesthesia (Septanest special, Septodont, Saint Maur des Fossés, France) and oral disinfection (Corsodyl mouth rinse, GSK, Wavre, Belgium), a large mucoperiosteal flap will be raised with two vertical releasing on each side of the edentulous space and at the distal aspect of the second neighboring tooth. The flap extends to the base of the alveolar process to allow full access. Autogenous bone chips are harvested from the retromolar area with bone scrapers and/or from an edentulous site using ACM bone collector (NeoBiotech, Guro-gu Seoul, Republic of Korea). DBBM particles (Xenogain, Nobel Biocare, Göteborg, Sweden) soaked in blood are mixed with autogenous bone chips to a ratio of 1/1. After having made multiple bone perforations at the buccal aspect of the recipient site, the mixture of bone chips and DBBM is applied. An individualized collagen membrane (Xenoprotect, Nobel Biocare, Göteborg, Sweden) or a non-resorbable titanium reinforced d-PTFE membrane is attached on top using membrane fixation pins. Prior to fixation of the final pin, bone grafting material is additionally applied from the lateral aspect to ensure that it is properly packed under the membrane and fully stable. Following release of the periosteum and muscle insertion, tension-free primary wound closure is achieved with horizontal mattress 4/0 titanium reinforced d-PTFE sutures and single 6/0 monofilament sutures. Patients continue the intake of antibiotics and anti-inflammatory medication for 7 days and use an oral mouthrinse during 2 weeks. Sutures are removed after 2 weeks, and an implant is installed after 9 months following 3D implant planning. A sample size calculation indicated 17 patients to be included per group. To compensate for one drop-out, 18 patients would be treated with collagen membrane and 18 would be treated with titanium reinforced d-PTFE. Changes in horizontal bone dimensions over time is the primary outcome. Prior to surgery, immediately after GBR, at 9 months, at 3 years and 5 years a CBCT is taken. Every CBCT is superimposed to the baseline CBCT in designated software and horizontal buccal bone dimensions are measured. Secondary outcomes include - Membrane exposure - Intrasurgical changes in bone crest width over time - Intrasurgical assessment of bone quality at implant placement at the palatal, midcrestal and buccal aspect - Need for re-grafting at implant placement - Need for soft tissue grafting at implant placement - Need for augmentation of keratinized mucosa at implant placement - Volumetric increase in buccal bone at 3 and 5 years - Peri-implant health at 3 and 5 years by means of intra-oral radiograph - Esthetic outcomes at 3 and 5 years - Histomorphometric analysis on 20 cases (10 per group)
In this clinical study ridge splitting procedures are preformed using autogenous bone blocks. After a 3-month healing, at the time of dental implant placement bone core biopsy samples are harvested. The samples undergo micro-Ct and histomorphometric analysis.
The aim of this study is to compare two pre-prosthetic surgical techniques for augmentation of vertical mandibular ridge defects in preparation for implant placement, the first using customized ceramic membranes and the second using tenting titanium screws in conjunction with particulate bone graft and collagen membrane (modified sausage technique).