Impact of Patient Position on the Success in Placing Triple-cuffed Double Lumen Endotracheal Tube

Lung Diseases Clinical Trial

Official title: Impact of Patient Position on the Success in Placing Triple-cuffed Double Lumen Endotracheal Tube : Multi-center Observational Study

Status Recruiting

Clinical Trial Summary

Triple-cuffed double lumen endotracheal tube (TC-DLT, ANKOR tube. Insung corp., Korea) which was developed to isolate lung without endotracheal bronchoscope guidance has additional carinal cuff placed between bronchial tube cuff and tracheal tube cuff. This device has been successfully used to isolate lung more simply in specific settings when there is too much excretion to visualize endotracheal structure or for a health provider who is not good at use of traditional double-lumen tube. Although TC-DLT is designed to enable lung separation effectively in situations that confirmation of tube position using bronchoscopy is difficult or not available, but no studies have been conducted on whether effective lung isolation using TC-DLT is possible after change in the relative position of the bronchial tree by postural change. This plan was prepared for research on this.

Clinical Trial Description

After enter into operating room, induction of anesthesia is performed through standard general anesthesia procedure before endotracheal intubation. Endotracheal intubation is performed using TC-DLT and inflate carinal cuff with 5 ~ 15ml of air. Then, push it into trachea until resistance is felt. When carinal cuff is placed at carina, deflate carinal cuff and isolate independent lung followed by confirmation of bronchial cuff position using fiberoptic bronchoscopy.

Record the location of the bronchial balloon in one of the following conditions

1. at proper position(proximal upper end of bronchial balloon is between 5mm from carinal opening) :

2. proximal end of bronchial balloon is placed more of 5mm distally from carinal opening

3. proximal end of bronchial balloon is placed more of 5mm proximally from carinal opening

Then, change patient position to left lateral decubitus (LLD) position and check the position of bronchial balloon using fiberoptic bronchoscopy as previously done.

1. at proper position(proximal upper end of bronchial balloon is between 5mm from carinal opening) :

2. proximal end of bronchial balloon is placed more of 5mm distally from carinal opening

3. proximal end of bronchial balloon is placed more of 5mm proximally from carinal opening

After check whether there is something to considerate, end this case. ;

Related Conditions & MeSH terms

• Lung Diseases

• NCT number: NCT05462275
• Study type: Interventional
• Source: Dongguk University International Hospital
• Contact: Hansu Bae
• Phone: 082-010-6326-1641
• Email: hsbae81@gmail.com
• Status: Recruiting
• Phase: N/A
• Start date: April 29, 2022
• Completion date: April 29, 2023