Clinical Trial Details
— Status: Completed
Administrative data
NCT number |
NCT02156687 |
Other study ID # |
14-354 |
Secondary ID |
|
Status |
Completed |
Phase |
N/A
|
First received |
|
Last updated |
|
Start date |
April 14, 2014 |
Est. completion date |
April 1, 2020 |
Study information
Verified date |
November 2020 |
Source |
The Cleveland Clinic |
Contact |
n/a |
Is FDA regulated |
No |
Health authority |
|
Study type |
Interventional
|
Clinical Trial Summary
The primary objective of the proposed study is to determine the difference in suturing time
when using the restorelle Y mesh versus the restorelle dual flat mesh at the time of
laparoscopic and robotic-assisted laparoscopic sacrocolpopexy.
Hypothesis: Suturing time when using the restorelle Y mesh will be faster than when using the
restorelle dual flat mesh at the time of laparoscopic and robotic-assisted laparoscopic
sacrocolpopexy.
Description:
Study Design: Randomized single-blind prospective clinical trial
Primary Outcomes:
1. Total Suturing time for mesh placement = time from insertion of Y mesh or first flat
mesh arm into pelvis to last sacral suture placed
2. Total Case time = Incision to end of closure
Secondary Outcomes:
Post-operative patient outcomes at 24-months
- Pelvic Floor Dysfunction Inventory (PFDI-20)
- Pelvic Organ Prolapse Distress Inventory (POPDI)
- Colorectal Anal Distress Inventory (CRADI)
- Urogenital Distress Inventory (UDI)
- Objective Recurrence (POP-Q)
- Subjective Recurrence (vaginal bulge)
- Reported mesh erosion
Study Population: Study subjects will be recruited from patients that present to the Center
of Urogynecology and Pelvic Floor Disorders in the Department of Obstetrics and Gynecology at
the Cleveland Clinic main campus, Hillcrest Hospital and Fairview Hospital, and their
surgeries will be performed at either one of these sites.
Study Procedures:
Study Identification and Recruitment Potential subjects will be identified by members of the
Center for Urogynecology and Pelvic Reconstructive Surgery at the Cleveland Clinic main
campus and Fairview Hospital. Eligible patients that agree to participate will be provided
written informed consent administered by the collaborators listed on this Investigational
Research Board (IRB) proposal at Cleveland Clinic Main campus and Fairview Hospitals.
Randomization All subjects will be predetermined by their surgeon to undergo either a
laparoscopic or robotic assisted laparoscopic sacrocolpopexy depending upon their clinical
evaluation. The participants will then be randomized to either Y mesh or dual flat mesh
sacrocolpopexy according to a computer-generated randomization schedule with random block
sizes with the use of the SAS statistical software package (SAS Institute, Cary, NC).
Randomization will be carried out by provider. All patients will be blinded to their
assignment.
Office Interventions In addition to a standardized evaluation including the history and
physical examination, patients will be asked to complete the Pelvic Floor Distress Inventory
(PFDI-20) questionnaire at the pre-operative visit as well as the 6, 12 and 24-month
postoperative visit. Completion of these questionnaire is the only additional assessment that
is specific to participation in this study and is not usually included as part of the
standard care of sacrocolpopexy. It should take no more than 10-15 minutes to complete the
questionnaire. The study subjects will not be exposed to any additional risk by participating
in this study except for the inconvenience of completing the questionnaire.
Surgical Interventions Laparoscopic sacrocolpopexy will be performed using four ports: an
umbilical port for the laparoscope, two ports (either 5 or 10/12 mm) in the bilateral lower
quadrants, and one 5-mm port placed at the level of the umbilicus, lateral to the rectus
muscle on either side for retraction. The robotic-assisted hysterectomy will be performed
using the da Vinci Surgical System (Intuitive Surgical Inc., Sunnyvale, CA, USA) using five
ports: a 12mm umbilical port for the laparoscopic, two 8 mm robotic ports placed 2cm inferior
and 9-10cm lateral to the umbilicus bilaterally, an 8mm robotic port placed in the left
axillary line at the level of the umbilicus, and a 8mm or 10/12mm accessory port either in
the right upper quadrant approximately 3cm distal from the costal margin, or in the right
lower quadrant, 2cm above and medial to the anterior superior iliac spine.
If a supracervical hysterectomy is to be performed, it will be done in a standard fashion. A
uterine manipulator will be placed inside of the uterus. The round ligaments will be
transected using cautery. The fallopian tubes and ovaries will be left in situ or removed at
the time of hysterectomy depending upon the preoperative decision made between the surgeon
and patient. The uterine arteries and cardinal ligaments will be cauterized laparoscopically.
The uterus will be amputated at the level of the internal cervical os and the endocervical
canal will be cauterized.
The sacrocolpopexy will also be performed and in a standard fashion. An end-to-end
anastomosis (EEA) sizer will be placed in the vagina for manipulation of the apex as well as
in the rectum for delineation of the rectovaginal septum. First, the presacral dissection
will be performed with a longitudinal peritoneal incision over the sacral promontory and
there is identification of the anterior longitudinal ligament. Dissection is then done
caudally through the peritoneum and subperitoneal fat down to the level of the posterior
cul-de-sac. The vagina is elevated cephalad using the EEA sizer and the peritoneum overlying
the anterior vaginal apex is incised transversely, and the bladder is dissected off the
anterior vagina using sharp dissection, creating a 4 to 5 cm pocket. If this plane is
difficult to establish, the bladder will be filled in a retrograde fashion to find the
correct dissection plane. Similarly, the peritoneum overlying the posterior vagina is
incised, and dissection is then done overlying the vagina and extending into the posterior
cul-de-sac, creating a 4 to 5 cm pocket. Once dissection is complete, the mesh graft is
prepared. Subjects will have been randomized to either one of two mesh grafts:
1. Restorelle Y mesh
- The mesh is introduced into the pelvis through one of the ports.
- First, either then anterior or the posterior arm is fixed to the anterior or
posterior vaginal wall using 5 delayed- absorbable (PDS) No. 2-0 sutures in an
interrupted fashion, 1 to 2 cm apart from each other.
- The opposing arm of the graft is then attached to either the anterior or posterior
vaginal wall, depending on which arm was placed first, in a similar fashion using 5
delayed- absorbable (PDS) No. 2-0 sutures in an interrupted fashion, 1 to 2 cm
apart from each other.
- The stem portion of the graft is then brought to the sacral promontory and sutured
to the anterior longitudinal ligament using 2 permanent (prolene) No. 0 sutures.
The excess mesh is then trimmed.
2. Restorelle dual flat mesh: 2 pieces of 15 x 4 cm mesh
- One mesh arm is introduced into the pelvis through one of the ports.
- The arm is fixed to the anterior or posterior vaginal wall using 5 delayed-
absorbable (PDS) No. 2-0 sutures in an interrupted fashion, 1 to 2 cm apart from
each other.
- The second mesh arm is then introduced into the pelvis through one of the ports.
- The arm is fixed to either the anterior or posterior vaginal wall, depending on
where the first arm was placed, using 5 delayed- absorbable (PDS) No. 2-0 sutures
in an interrupted fashion, 1 to 2 cm apart from each other.
- The two arms are then brought to the sacral promontory and sutured together to the
anterior longitudinal ligament using 2 permanent (prolene) No. 0 sutures. The
excess mesh is then trimmed.
The peritoneum is then closed over the exposed graft with absorbable suture. Routine
cystoscopy will also be performed in order to assess for lower urinary tract injury. A
vaginal exam is performed, and an anterior and/or posterior colporrhaphy and perineorrhaphy
are performed if needed. Anti-incontinence procedures may also be performed if needed.
**In laparoscopic cases, all suturing will be done extracorporeally while intracorporeal
knot-tying technique will be performed in robot assisted laparoscopic cases.