Malocclusion, Angle Class II Clinical Trial
Official title:
The Effect of Timing on Orthodontic Treatment - Studied by Randomized Clinical Settings
The aim of this longitudinal randomized investigation is to determine the long-term effects
of early headgear treatment on craniofacial structures and dental arches, compared to
treatment started later, during the most active growth period in Class II patients.
The aim was further to find out the possible benefits and the burden of early treatment to
the patients and parents of these common malocclusions, when compared to groups treated
later, but with the same methods as much as possible.
The hypothesis is that the timing of treatment has significant effects on orthodontic
treatment total time, the general outcome of the treatment, and the compliance of the
patient.
1. Background In spite of the fact that about 30 to 50% of the children in Europe undergo
orthodontic treatment during growth, negligible amount of evidence based data is
available concerning these treatments.
The most used treatment method in Finland, and one of the most popular in the world, is
to treat dental crowding and class II malocclusion with the headgear (Mäntysaari et al.,
2004; Pirttiniemi et al., 2005; Pietilä et al., 2008).
The goal of the HG treatment is variously listed as to inhibit maxillary growth, to
stimulate mandibular growth, or to ease the crowding. During the recent years McNamara
(2002) and Fenderson et al (2004) have emphasized the advantages of the lateral
expansion of dental arches in the treatment of crowding, especially stressing the
stability of the results.
The views of the effects of cervical headgear (HG) are to some extent obscure, at least
when the long-term effects are concerned. Most reports that are based on a short-term
follow-up, describe a restricted maxillary anterior growth. During the later growth, it
is not clear what is the general association of early orthodontic treatment on crowding,
but our earlier results show that in the final outcome there is no significant
difference in stability of the treatment if crowding is treated with early headgear or
later with fixed appliances only, at least when the long-term effects of the treatment
are concerned (Krusinkiene et al., 2008).
A valid evidence based data is rare and the thus exact conclusions are very difficult to
be set (Petrén and Bondemark, 2008).
2. Preliminary Studies We conducted a randomized clinical study with an early headgear
treatment, where the control group was treated with a camouflage treatment in the
adolescence. The main difference between the groups was broader dental arch with less
extractions in the headgear group, the differences between the groups being relatively
small when the craniofacial differences or the stability are concerned (Mäntysaari et
al.,2004; Pirttiniemi et al.,2005; Krusinskiene et al., 2008). There were, however, some
distinct profile differences between the groups and the canine eruption pattern was
found to be more favorable in the early headgear group (Silvola et al., 2008; Virkkula
et al., 2008).
3. Experimental Design and Methods
- The Age cohort of six-year-old of children living in the community areas of Kemi,
and Oulunsalo are screened at the age of 6 years for malocclusions. Of these
children 120 children who meet the criteria are chosen for the study after the
written consent. The inclusion criteria are Class II malocclusion, Overbite 5 mm or
more.
- Exclusion criteria are openbite tendency as verified in cephalometry, missing
permanent teeth, lateral malocclusion, or craniofacial anomaly.
- The children are randomized into two groups. In the first group the treatment with
headgear device (GAC, Islandia, NY, USA) is started at the age of 7 to 8 years, and
continued until Class I occlusion is achieved. In the second group headgear
treatment is started before the pubertal growth spurt, verified by standing height
measurements.
In both groups all the necessary orthodontic treatment is done with fixed appliances,
after the headgear treatment, when found necessary.
-In both groups dental casts, cephalograms, and standardized profile and facial
photograps are taken before treatment (T0), after the first treatment phase (T1), after
the second treatment phase (T2) and after the growth (T3).
Facial 3D scanning is performed for all the subjects after the treatment to find out the
effect of different treatment methods on facial characteristics. The dental casts are
scanned to make 3D models of the cast to be used in detailed analysis.
- A wide multi-level questionnaire is performed before, during and after the study to
the parents and the children to find out the comprehensive effects of orthodontic
treatment on the well-being of the child. The questionnaire includes the Rutter's
child behavioural pattern (Rutter et al., 2001).
- In both studies, all the guidelines of RCT are applied (Moher and Schulz, 2005).
Blinding of the clinicians is gained, as the orthodontists or dentists treating the
children are not aware of the rationale of the study. Blinding is applied on all
measurement of the documents.
4. Quality assurance plan Quality of the data collected is secured by preliminary training
that has been done concerning the input data and the registration processes. The
collected data is monitored on regular basis, on clinical records this is done by three
months intervals. The quality assurance of the clinical data is done by the same person
who has trained the dental personnel by on-site monitoring and auditing. Immediate
feed-back is given to the registering personnel concerning the quality of the records.
The input data is monitored by testing the normality of the data during the input
process. Immediate feed-back is given to the personnel doing the registration process in
the cases of deviation is found in the range of normality or consistence of the data.
Basic assumption is that the input data is supposed to be normally distributed with this
type of patient material.
Intra- and Inter-examiner error is tested during the measuring process to test the
accuracy of the measurements. The level of error is compared to the level of level
reached in corresponding studies.
5. Sample size assessment Power and sample size calculation was made using the data derived
from the preliminary studies (Mäntysaari et al., 2004), and the applied sample size was
gained using the formula for the
purpose:(http://stat.ubc.ca/~rollin/stats/ssize/n2.html).
The used estimates for means and deviations were gained from the analogous preliminary
study. The test power used in the power analysis was 0.80 with the level of significance
p=0.05. The used value give the sample size 49, and thus the used sample is very
sufficient.
6. Plan for missing data It is known from earlier longitudinal orthodontic studies that the
drop-out rate is about 20% when reaching the end point of the study. This has been taken
into account in the original sample size. As randomization is applied, it is likely that
the missing subjects will occur approximately at the same rate in both study groups and
by choosing appropriate statistical methods, the data can be handled.
7. Statistical analysis plan The study hypothesis is tested by using statistical methods.
When the differences between the two groups are tested, a test for two independent
samples is utilized. When the values of the children are compared at different time
points, a test of related samples is used. If the sample data is not normally
distributed, a non-parametric test is applied ( e.g. Mann-Whitney-test or
Wilcoxon-test). When the behavioral items are tested, the applied tests are on ordinary
level or nominal level (e.g. Cross-tabulation tests).
To estimate the Intra-examiner and Inter-examiner error, double measurements are
performed. The statistical testing of the error is done using Intra class correlation
(ICC).
The Intention to treat principle is applied in the study The results will be shown both
in graphical and table format to clearly show group and individual variation. The
statistical testing is done by using the latest version of SPSS program.
8. Timing and Importance of the studies The first part of the study (the headgear study)
has begun in 2005. The study will continue actively during the years 2005-2014.
The treatments and the follow-up continues until the growth is over, until about year
2018, and further until the adulthood. Most of the data, however, is available to be
analyzed already earlier in 2013-2014.
The results of these studies are clinically very important and therefore they will be
published in the most respected international orthodontic journals. As the results are
of the highest clinical relevance with a sound evidence, they can easily be applied
directly to clinical practices.
University of Oulu will give all the facilities needed for the research, including
rooms. The clinical examinations are performed in the health centers as a part of normal
treatment costs, when normal documentation is concerned.
9. REFERENCES
E. Literature Cited:
Fenderson FA, McNamara JA Jr, Baccetti T, Veith CJ. A long-term study on the expansion
effects of the cervical-pull facebow with and without rapid maxillary expansion. Angle Orthod
2004;74:439-449.
Krušinskienė V, Kiuttu P, Julku J, Silvola A-S, Kantomaa T, Pirttiniemi P. A randomized
controlled study of early headgear treatment on occlusal stability - a 13 year follow- up.
Eur J Orthod 2008;30:418-24 McNamara JA Jr. Early intervention in the transverse dimension:
is it worth the effort? Am J Orthod Dentofacial Orthop 2002;121:572-4.
Moher D, Schulz KF, Altman D. The CONSORT Statement: revised recommendations for improving
the quality of reports of parallel-group randomized trials 2001.Explore 2005;1:40-5.
Mäntysaari R, Kantomaa T, Pirttiniemi P, Pykalainen A. The effects of early headgear
treatment on dental arches and craniofacial morphology: a report of a 2 year randomized
study. Eur J Orthod 2004;26:59-64.
Petrén S, Bondemark L.Correction of unilateral posterior crossbite in the mixed dentition: a
randomized controlled trial.Am J Orthod Dentofacial Orthop. 2008;133:790.e7-13.
Pietilä I, Pietilä T, Pirttiniemi P, Varrela J, Alanen P. Orthodontists' views on indications
for and timing of orthodontic treatment in Finnish public oral health care. Eur J Orthod
2008;30:46-51 Pirttiniemi P, Kantomaa T, Mantysaari R, Pykalalinen A, Krusinskiene V, Laitala
T, Karikko J. The effects of early headgear treatment on dental arches and craniofacial
morphology: an 8 year report of a randomized study. Eur J Orthod 2005;27:429-36 Rutter M,
Pickles A, Murray R, Eaves L.Testing hypotheses on specific environmental causal effects on
behavior. Psychol Bull 2001;127:291-324.
Sivola AS, Arvonen P, Julku J, Lähesmäki R, Kantomaa T, Pirttiniemi P. Early headgear effects
on the eruption pattern of the maxillary canines. Angle Orthodont 2009;79:540-5 Virkkula T,
Kantomaa T,Julku J, Pirttiniemi P. The long-term soft-tissue response to orthodontic
treatment with early cervical headgear - a randomized study. Am J Orthod Dentofac Orthoped
2009;135:586-96
;
Status | Clinical Trial | Phase | |
---|---|---|---|
Recruiting |
NCT06297109 -
Maxillary Patient Specific Implants in Bimaxillary Orthognathic Surgery
|
N/A | |
Recruiting |
NCT05227469 -
Myofunctional Therapy Twin Block
|
N/A | |
Completed |
NCT05356780 -
Predictability of Orthodontic Tooth Movement With Invisalign Aligners
|
||
Not yet recruiting |
NCT05467579 -
Mandibular Advancement Clear Aligner Treatment in Juvenile Idiopathic Arthritis Subjects
|
N/A | |
Completed |
NCT01530516 -
Crossbow Versus Forsus Springs in Mild to Moderate Class II Malocclusion Cases
|
N/A | |
Recruiting |
NCT04875104 -
Upper Sequential Distalization With TADs and Aligners
|
N/A | |
Not yet recruiting |
NCT05853211 -
Therapeutic Effects of Class II Elastics on Aligners in Different Vertical Skelettal Patterns
|
||
Completed |
NCT04175405 -
Low-level Laser Therapy With a 635nm Diode Laser on Orthodontic Mini-implants Stability.
|
N/A | |
Completed |
NCT02456220 -
Dentoskeletal Changes Associated With Herbst Appliance Therapy
|
N/A | |
Recruiting |
NCT05950581 -
Treatment of Skeletal Class II Malocclusion With Modified Twin-Block Appliance With Clear Plates
|
N/A | |
Completed |
NCT03645343 -
The Effect of Functional Treatment of Patients With Backward Positioned Chins on the Jaw Joint and Movements
|
N/A | |
Completed |
NCT04276402 -
Effect of Photobiomodulation by 808nm Diode Laser on the Stability of Orthodontic Mini-implants.
|
N/A | |
Completed |
NCT03239912 -
Treatment of Class II Malocclusion Combined With Low-level Laser
|
N/A | |
Recruiting |
NCT03773783 -
Study to Compare Two Functional Appliances for Class II Malocclusions
|
N/A | |
Recruiting |
NCT05499221 -
Bone Anchored Carriere Motion Appliance
|
N/A | |
Completed |
NCT03159962 -
Mandibular Response After Maxillary Orthopedic Expansion in Class II Growing Subjects
|
N/A | |
Completed |
NCT06240923 -
"Three Dimensional Assessment of Maxillary Molars Following Distalization Using Two Different Approaches"
|
N/A | |
Completed |
NCT05298280 -
Vertical Effects in Class II Patients Treated With Distalization
|
N/A | |
Completed |
NCT04556448 -
RCT Comparing Invisalign and Traditional Orthodontic Treatment
|
N/A | |
Completed |
NCT03455634 -
Predictors Associated With Seeking Orthodontic Treatment, Compliance and Treatment Success
|
N/A |