Clinical Trial Details
— Status: Completed
Administrative data
NCT number |
NCT04019145 |
Other study ID # |
28909092104862 |
Secondary ID |
|
Status |
Completed |
Phase |
Early Phase 1
|
First received |
|
Last updated |
|
Start date |
September 1, 2020 |
Est. completion date |
September 30, 2021 |
Study information
Verified date |
November 2021 |
Source |
Cairo University |
Contact |
n/a |
Is FDA regulated |
No |
Health authority |
|
Study type |
Interventional
|
Clinical Trial Summary
A clinical trial, comparing two different incrementation techniques in the restoration of
proximal caries in permanent posterior teeth . One utilizes a fiber reinforced bulk fill base
material, followed by an occlusal nanohybrid capping layer. The other utilizes incremental
packing of nanohybrid resin composite material to fill the whole cavity.
Description:
The aim of this study is to conduct an RCT to evaluate the clinical performance of the fiber
reinforced bulk fill resin composite in comparison to incremental packing of nanohybrid resin
composite.
Examination and selection of all patients will be done according to inclusion and exclusion
criteria. Diagnosis of patients' chief complaint and teeth that will be involved in this
study will be done. Teeth are to be chosen according to standardized radiographic
examination. Teeth should have proximal, primary deep carious lesions involving 2/3 of the
entire dentin thickness with no continuity between the carious cavity and the pulp chamber.
A Class II cavity will be prepared after local anesthesia has been given as required. The
cavity will be prepared using a high-speed hand-piece with air and water coolant and diamond
burs of different sizes. Sharp excavators will allow accessible removal of soft carious
lesions will be used. Any tooth that will suffer from pulpal exposure will be excluded from
the study. Finishing of the cavity walls will be done using a fine-grit, yellow coded,
diamond bur.
Rubber dam isolation will be done.
Sectional matricing and wedging will be done. Followed by, placement of restorative material
according to the randomization sequence.
A closed centripetal technique will be utilized, where a proximal wall will be built using
nanohyrbid resin composite first, followed by filling of cavity with bulk-fill fiber
reinforced resin composite material in increments of 3-4mm, as required to end up with
leaving an occlusal space on top of at least 2mm. Then, an occlusal increment of nanohybrid
resin composite will be applied. Finally finishing and occlusal adjustment will be done under
water spray by using superfine diamond burs. Polishing will be done using pre-impregnated
rubber cups. Materials will be manipulated according to manufacturer instructions.
A closed centripetal, oblique incrementation technique will be used to completely fill the
whole cavity. Increments should be of 2mm thickness or less and should be placed obliquely
from the cavity walls. Then finishing and occlusal adjustment will be done under water spray
by using superfine diamond burs. Polishing will be done using pre-impregnated rubber cups.
Materials will be manipulated according to manufacturer instructions
Outcome Measuring Device: modified USPHS criteria .
Primary Outcomes:
Mechanical evaluation:
Fracture and Retention Marginal integrity Marginal Discoloration Anatomic Form Surface
Texture Proximal Contact Radiographic Examination
Secondary Outcomes:
Biological evaluation:
Postoperative Sensitivity Recurrent Caries